Is anyone else having HORRIBLE problems with their Prusa Mk4 or Mk4S first layer quality...
My mk4s developed a problem that Prusa spent 3 months troubleshooting with me where the first layer is being laid down too close, and so filament blobs, then prints fail.
Eventually, they advance replaced my whole printer, and the new one had the exact same problem out of the box..
I managed to find a bug that was raised on github for this exact issue, with 22 other people registering "mee too" for the issue..
I'm just looking for some feedback from the wider community to see if any others have hit this problem?
I've only ever had the opposite issue with the nozzle being too far away from the bed due to the bed leveling using a dirty nozzle because the nozzle "cleaning" rutine uses a way too cold nozzle temperature so the plastic is not soft enough to be pushed away and the filament is not retracted so it also oozes because it has been heated for too long. Imo the printer should purge, then retract then clean and then bed level.
Can't you just change this? Or are Prusa so locked down that they don't allow control of the printer?
If you wanted to customise the starting gcode, I'm sure you could.