dactylmanuform

joined 2 years ago
sorted by: new top controversial old
12
Only few keys working on dactyl manuform (lemmy.world)
 

I'm doing dactyl manuform first time (also my first ergo. keebs). Buying parts, soldering, wiring matrix like instruction. When i plugged in computer and flashing firmware, it only respond D, F, Space keys

I don't know why it doesn't work like it supposed to be, i have unpluged the pro micro, plugged and flash firmware again, and the problem is still there

Can someone see what wrong with my wiring?

8
Can i use the black tape (electrical tape) to prevent the short of circuit board? (lemmy.world)
 

I have read about some guides and in the progress doing the dactyl manuform, and I have seen that many people used some tape called "kapton tape" or used some shells pulled out from the wire to seperate the columns and rows of the matrix.

I want to know that is it safe to use the electrical tape for this purpose because I have read some comments said that the electrical tape will melt and cause everything around it sticky.

I have some more question about building dactyl manuform in c/ergomechkeyboards@lemmy.world
[–] dactylmanuform@lemmy.world 1 points 2 years ago (1 children)

Elite-C is not available in my country, so the shipping cost will be really expensive. I'm looking for cheaper option

6
I have some more question about building dactyl manuform (imgur.com)
submitted 2 years ago* (last edited 2 years ago) by dactylmanuform@lemmy.world to c/ergomechkeyboards@lemmy.world
5 comments fedilink
 
  1. I have received a 3d printed dactyl manuform, and i have realized that most of parts used to hold the kailh hotswap socket is broken. So I want to know which glue is safe for plastic ( it will not melt the plastic ) and can be strong enough to prevent the socket from fly away from the case.
  2. Can I use Type-C USB 3-18V adruino instead of Pro Micro USB adruino? Because as what I can see, the specs of two adruinos written on the chip are nearly the same:

(-) Pro Micro USB adruino: ATMEGA32U4; -MU; 2147E; 2147YHE PH

(-) Type-C USB 3-18V: ATMEGA32U4; -MU; 2216E; 2216QG7 PH

https://imgur.com/a/dxgjyGL (link to images of 2 adruinos)

10
is dactyl manuform having hot-swap function a good idea? (lemmy.world)
 

I have do some research about doing dactyl manuform, and I see people mostly solder directly diodes and copper wire to the switch. So i want to know that if i build dactyl manuform with hotswap function, will there have some problems which can kill my board? And when comparing handwired and hotswap. which is easier to do if i'm a beginner? And another question: is reset buttons neccessary for this build? (because i saw many guides are always including this component)