this post was submitted on 20 Jun 2025
174 points (98.3% liked)
Sysadmin
10179 readers
1 users here now
A community dedicated to the profession of IT Systems Administration
No generic Lemmy issue posts please! Posts about Lemmy belong in one of these communities:
!lemmy@lemmy.ml
!lemmyworld@lemmy.world
!lemmy_support@lemmy.ml
!support@lemmy.world
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I've got it covered :) - whole duplicate set of hardware & drive image. Recapped the board last year & replaced PSU too.
I won't touch the DOS software it uses to actually run the plant, the lads can have at that.
Rock and roll. I've seen bad things happen when someone decides it's a good idea to modernize a PC based CNC control. (I hate PC based controls). They get their own little fence to live inside where it's always 1999.