Prusa Research

217 readers

1 users here now

A Community for discussing all things related to specifically Prusa Researchs 3D Printers like the MK3, MK4, Mini and XL

founded 2 years ago

MODERATORS

TheYang@lemmy.ml

Mk4 (nephele.dedyn.io)

submitted 8 months ago* (last edited 8 months ago) by Carunga@feddit.de to c/prusa@lemmy.ml

5 comments fedilink hide all child comments

Hello folks! Build a MK4 4 months ago and was very happy with it so far. Now I have bed adhesion problems (see pic attached). 3 weeks ago I had similar problems and after a chat with prusa and resetting the calibration / cleaning the build plate again it worked fine. Now the problem is back despite a clean build plate . After resetting the calibration I got one nice print and then the same problem again. Cold pull of the nozzle resulted in a clean tip and no better results, so I do not think there is any clogging. Also the plate and the should be alright, as I got good results inbetween. Any ideas / hints where my problem is? Link leads to image of the problem. Could not upload the file for some reason...

you are viewing a single comment's thread
view the rest of the comments

[–] Carunga@feddit.de 1 points 8 months ago

Thanks, will clean it again, this time as you suggested. Usually I use the isopropanol on the cold plate.