homeassistant

13377 readers

12 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Bed Occupancy Sensor? (lemmy.ml)

submitted 1 day ago by Practical_Plan_2560@lemmy.ml to c/homeassistant@lemmy.world

41 comments fedilink hide all child comments

Anyone try to build a bed occupancy sensor integrated with Home Assistant? I've looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don't think it would even support the empty bed).

What devices/sensors have you used for this? And what does your setup look like?

you are viewing a single comment's thread
view the rest of the comments

[–] bus_factor@lemmy.world 1 points 1 day ago (2 children)

I've never done anything like this, but would it be possible to place such a sensor between the mattress and the frame instead? That would result in a fraction of the load due to the distribution of the weight. The challenge would be to set the threshold right.

[–] meltedcheese@c.im 1 points 1 day ago

@bus_factor Some of the #mmWave (Radar) Presence sensors may be able to detect bed presence through the mattress, mounted under frame. I have not tried this yet but I’ve been planning to. The Aqara FP-1 or Aqara FP-2 are candidates, but maybe too pricey for an experiment. The Apollo MTR-1 is far less expensive and excellent for short range. It is also small and with a sturdy enclosure you could easily place it between and mattress. These sensors can pick up very small motions, even the human heartbeat (sometimes through walls). I use both Aqara (easier set up) and Apollo MTR-1 for room and zone presence detection, with #HomeAssistant for integrated automation.

load more comments (1 replies)